GTI L4-2.0L Turbo (CBFA) (2008)
-
Disengage securing clip -2- using a screwdriver and pull out of master cylinder until it stops.
-
Disconnect hose/line assembly or plastic line -1- from master cylinder and seal it.
-
Disconnect electrical connector -4-.
-
Unclip Clutch Position Sensor G476 on master cylinder -arrow- and remove.
Installing
Installation is in reverse order of removal. Pay attention to the following:
Note: Allocate all components.
If the hose/line assembly or plastic line was removed:
-
Press in hose/line assembly or plastic line -1- with new seal -2- on master cylinder connection -4- until securing clip -3- engages audibly.
-
Pull on line to check.
-
After removing Hose Clamps up to 25 mm dia. 3094, bring return hose back to its original shape.
-
Bleed clutch system.
All vehicles
-
Install battery carrier and battery.
-
If removed, install entire air filter housing.
-
Connect battery and observe the work procedures for after connecting the battery.