GTI V6-2.8L (AFP) (1999)
/Page-2076001.png)
Hood Shock / Support: Procedures
-
Clamp gas-filled strut in vice in area x = 50 mm (2 in.).
WARNING: Only clamp the strut within the indicated area. If clamped outside the indicated area there is danger of an accident!
-
Saw through cylinder of gas-filled strut within first third of cylinder's overall length. Use piston rod end of cylinder as reference point.
NOTE:
-
Wear protective goggles during the sawing process.
-
Cover the area of saw cut with a cloth to block escaping oil.
-
Dispose of oil and cloth properly