GTI V6-2.8L (BDF) (2002)
Headliner: Service and Repair
Molded Headliner, Removing and Installing (Vehicles With Sunroof)
Molded Headliner, Removing And Installing (Vehicles With Sunroof)
NOTE:
-
Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.
-
Before disconnecting battery, see note in Owners Manual concerning radio.
-
Obtain radio anti-ft code before disconnecting battery.
Removing
CAUTION: Disconnect battery ground (GND) strap before working on electrical system.
-
Switch ignition off.
-
Remove upper A pillar trim:
-
with side curtain protection.
-
without side curtain protection.
-
Remove upper B-pillar trim:
-
with Side curtain protection --> 04.01.
-
with Side curtain protection 05.01 -->.
-
without Side curtain protection.
-
Remove roof end strip:
-
Golf.
-
Golf wagon/Jetta wagon.
-
Loosen upper C-pillar trim:
-
Golf with Side curtain protection .
-
Golf without Side curtain protection.
-
Jetta with Side curtain protection.
-
Jetta without Side curtain protection.
-
Golf wagon/Jetta wagon with Side curtain protection --> 04.01.
-
Golf wagon/Jetta wagon with Side curtain protection 05.01 -->.
-
Golf wagon/Jetta wagon without Side curtain protection.
-
Remove upper D-pillar trim (Golf wagon/Jetta Wagon): Upper D-pillar trim, removing and installing (Golf wagon/Jetta wagon).
-
Remove sun visor.
-
Remove center sun visor.
-
Remove grab handle (roof).
-
Remove door inner seals at top.
-
Unclip trim - 1 - in direction of - arrow - and remove.