GTI V6-2.8L (BDF) (2002)
-
Clean dirt from all seams so that no damage to paint will occur when removing components.
-
Cover all adjacent paint surfaces and gap between roof and rear lid with tape.
-
Spooling tool must be applied in depicted position and one cord end must be secured.
-
Insert cutting cord around spoiler so that cord passes along outside in seam between spoiler and rear lid and secure second cord end to wiper axle.
-
While cutting free, guide cutting cord into seam using a plastic wedge.
-
In position illustrated, spoiler can be cut free to slightly past vehicle center.
-
Then, position spooling tool corresponding to illustration and swap cord ends. Then cut free spoiler from other outer side toward center.
-
Remove spoiler.
Installing roof edge spoiler