GTI V6-2.8L (BDF) (2002)
-
Disconnect speed sensor and speed sensor wiring connector -1-.
-
Remove bolt -2- from wheel bearing housing.
-
Pull ABS speed sensor from wheel bearing housing.
Installing
-
Before inserting speed sensor, clean mounting hole inner surface and coat speed sensor with solid lubricant paste G 000 650.
-
Insert speed sensor into mounting hole in wheel bearing housing and tighten bolt to 8 Nm (71 inch lbs.).
-
Connect speed sensor to speed sensor wiring connector.
-
Turn wheels fully left and right lock and check clearance to speed sensor wiring.
Rotor on front axle, checking or removing and installing
-
Raise vehicle.
-
Remove wheel.
-
Rotate brake disc and check rotor is damaged or dirty.
-
If rotor is damaged, remove wheel hub with rotor and replace.
Rotor, Checking or Removing and Installing
Rotor on Front Axle, Checking or Removing and Installing
-
Raise vehicle
-
Remove wheel
-
Rotate brake disc and check rotor is damaged or dirty.
-
If rotor is damaged, remove wheel hub with rotor and replace.
Speed Sensor Wiring, Removing and Installing
Front speed sensor wiring, removing and installing
Special tools and equipment
-
VAS 1978 Wiring harness repair set