GTI V6-2.8L (BDF) (2002)
NOTE:
-
The compressor bracket and related components can be removed and installed without discharging the refrigerant circuit.
-
Compressor can only be serviced or replaced after discharging refrigerant system. Use Kent Moore ACR4 or equivalent.
1
-
Clutch plate bolt
-
15 Nm (11 ft. lb.)
-
Removing and installing See Fig. 1
2
-
Clutch plate
-
Removing See Fig. 2
3
-
Shims
-
To adjust gap between clutch plate and pulley
-
Gap: 0.3 - 0.6 mm (0.0118 - 0.0236 in.)
-
Gap, checking See Fig. 6
4
-
Circlip
-
Always replace
-
Flat side must face compressor
-
Must be seated correctly in groove
5
-
Clutch pulley
-
Removing See Fig. 3
-
Installing See Fig. 4
6
-
Circlip
-
Always replace
-
Flat side must face compressor