GTI V6-2.8L (BDF) (2002)
Headlamp Alignment Actuator: Service and Repair
Headlight Beam Adjusting Motor* (Golf), Removing And Installing
NOTE:
- Beam adjusting motor can only be removed and installed with headlight housing removed.
- If positioning motors are removed and installed or replaced, always carry out headlight basic setting with VAS 5107 Optical headlight aimer.
Inclination dimension is embossed on headlight housing.
Removing
-
Remove headlight.
-
Release spring clip -arrow- and remove sealing cover.
-
Disconnect electrical connector.
*) Where applicable
-
Release left-hand positioning motor -arrow- by turning to left and right-hand by turning to right.
-
Pull positioning shaft ball head out of locking device on reflector.
Installing