GTI V6-2.8L (BDF) (2002)
-
Slowly depress accelerator pedal up to Wide Open Throttle (WOT) stop while observing the percentage display.
The percentage display must increase uniformly.
-
Check specified value of throttle valve position (absolute) at Wide Open Throttle (WOT) stop:
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Disconnect the 6-pin connector at the throttle valve control module (arrow).
Check resistance
-
Measure resistance of Throttle drive (power accelerator actuation) -G186- in Throttle Valve Control Module -J338- between terminals 3 + 5
Specified value: 1.0...5.0 Ohm
If specified value is not obtained:
-
Replace Throttle Valve Control Module -J338-: