GTI V6-2.8L (BDF) (2002)
Indicated on display:
Read measured value block
Input display group number XXX
-
Press buttons -0-, -6- and -6- for "Display group number 66" and confirm entry with -Q- button.
Indicated on display: (1...4 = display zones)
Read measured value block 66
1
2
3
4
-
Observe display in display zone 2 (6th digit from left).
Specification: xxxxx0xx
-
Depress clutch pedal fully and observe values in display zone 2.
Specification: xxxxx1xx
-
Press the -> button.
-
Press buttons -0- and -6- for function "End output" and confirm entry with the -Q- button.
-
Switch off ignition.
If the specifications are not obtained:
-
Remove cover in footwell (driver's side).
-
Pull 4-pin connector off Clutch Vacuum Vent Valve Switch -F36- arrow-.
-
Measure resistance between switch terminals 2 and 3.
Specification
Clutch not depressed: max. 1.5 ohms
Clutch depressed: infinity ohms
If the specifications are not obtained:
-
Replace Clutch Vacuum Vent Valve Switch -F36-.
NOTE: Observe installation position of Clutch Vacuum Vent Valve Switch -F36- through upper assembly hole of bearing bracket.
-
Check DTC memory, repair malfunctions if necessary and then erase DTC memory.
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If the DTC memory has been erased or the Motronic Engine Control Module (ECM) -J220- was disconnected from battery
positive (B+), the readiness code must be generated again.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If the specifications are obtained: