GTI V6-2.8L (BDF) (2002)
positive (B+), the readiness code must be generated again.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Aging Check
Heated Oxygen Sensor (HO2S), Checking Aging
Special tools, workshop equipment, testers, measuring instruments and auxiliary items required
-
VAG 1551 Scan tool (or VAG 1552) with VAG 1551/3 adapter cable
NOTE: All functions which could previously be performed with VAG 1551/1552 can also be performed with the VAS 5051.
Test prerequisites
-
The fuses must be OK.
-
The battery voltage must be at least 11.5 V.
-
All electrical accessories, e.g. lights and rear window heating must be switched off.
-
If the vehicle is equipped with air conditioning, it must be turned off.
-
Selector lever must be in position "P" or "N" on vehicles with an automatic transmission.
-
Exhaust system between Three Way Catalytic Converter (TWC) and cylinder head must be free of leaks.
-
Engine Coolant Temperature (ECT) must be at least 85 degrees C, See display group 1, display zone 2.
-
Three Way Catalytic Converter (TWC) temperature must be at least 380 degrees C, See display group 34, display zone 2.
Functional check
-
Connect VAG 1551 Scan tool (or VAG 1552) and select engine electronics control module with the "Address word" 01. When doing this the
engine must be running at idle speed: ((VAG 1551 and Motronic Engine Control Module (ECM) -J220-, connecting and selecting).
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Manufacturer's Scan Tool/Connecting VAG
1551 Scan Tool
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -4- for function "Initiate basic setting" and confirm entry with -Q- button.