GTI V6-2.8L (BDF) (2002)
-
Unclip and remove lower cover -6- by sliding rearward out of clips
-
Using a volt meter, check the terminal contacts of the 15 amp fuse in position B -arrow- for 12 volts or B+ power) and make note of terminal
position in fuse housing
-
Under hood, remove battery cover and disconnect battery ground (GND) cable
-
Remove fuse/relay holders -A- and -C- (arrows) at the bottom of the lower relay panel
-
Remove fuse holder -B- from the bottom of lower relay panel -arrow- and remove fuse from holder
-
Remove (2) nuts -A- and pull lower relay carrier rearward and down to remove
-
Remove the B+ terminal (as previously found) from fuse holder B -arrow-
NOTE: The illustration shows the wire removed from position #2, however, your vehicle could be different
-
Insert the B+ terminal (removed from fuse holder) into terminal housing -11- (191 972 751 or 1J0 972 751)