GTI V6-2.8L (BDF) (2002)
15 -
Connector
-
Black, 3-pin
-
Sensor and connector terminals are gold plated
-
Mark connector and component before pulling connector off.
16 -
Camshaft Position (CMP) Sensor -G40-*
-
For inlet camshaft
-
Sensor and connector terminals are gold plated
17 -
Knock sensor (KS) 2 -G66-*
-
Component location: Between cyl. 4 and cyl. 6
-
The terminal surfaces between Knock sensor (KS) and cylinder block must be free of corrosion, dirt and grease.
-
Sensor and connector terminals are gold plated
18 -
Connector
-
Black, 2-pin
-
Sensor and connector terminals are gold plated
19 -
Camshaft roller chain
-
Mark direction of rotation before removing (installation position)
20 -
Inlet camshaft adjuster
-
Marking: 24E
-
Turn engine over only when camshaft timing adjuster is installed
-
With sensor wheel for Camshaft Position (CMP) Sensor 2 -G163-
-
If the camshaft timing adjuster has been removed, after installing check timing:
-
Check camshaft timing adjustment:
21 -
Camshaft Adjustment Valve 1 (exhaust) - N318-*/**
-
For exhaust camshaft
-
Mark connector and component before pulling connector off.
-
Check camshaft timing adjustment:
22 -
Valve -1- for camshaft adjustment -N205- */**
-
For inlet camshaft
-
Mark connector and component before pulling connector off.
-
Check camshaft timing adjustment:
23 -
Spark plug, 25 Nm
-
Remove and install with spark plug wrench 3122B
-
Type and electrode gap