GTI V6-2.8L (BDF) (2002)
12
-
Belt guide
Front Seatbelts, Removing and Installing
Front Seatbelts, Removing And Installing
NOTE:
-
Removal and installation is described for right side of vehicle. same instructions apply for removal and installation for left-hand side.
-
Two different belt tensioners are installed: Belt tensioners with electrical igniters in vehicles with side airbag and belt tensioners with mechanical
igniters in vehicles without side airbag.
Removing
-
Disconnect vehicle battery
-
Remove lower B-pillar trim.
-
Remove sill panel trim:
-
2 door.
-
4 door.
CAUTION: Observe safety precautions for belt tensioners.
-
Remove bolt - 10 - (40 Nm) and remove belt mount from body.
-
Remove screw - 9 - (40 Nm) and remove automatic belt retractor - 8 - off B-pillar.
CAUTION: Electrostatic charges may result in involuntary deployment of belt tensioner. Therefore, mechanic must be electrostatically
discharged before disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping chassis or door striker.
-
Disconnect harness connector - 7 -.
-
Remove two bolts - 11 - (1.5 Nm) and remove belt guide - 12 -.
-
Clip on cover cap - 4 - for belt relay - 3 -.
-
Remove screw - 5 - (40 Nm) and remove belt relay - 3 - off belt height adjuster -1 -.