volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABS ITT Mark 20 IE|Page 571 > < ABS ITT Mark 20 IE|Page 569
Page 2
background image

-

Disconnect speed sensor and speed sensor wiring connector -1-.

-

Remove bolt -2- from wheel bearing housing.

-

Pull ABS speed sensor from wheel bearing housing.

Installing 
-

Before inserting speed sensor, clean mounting hole inner surface and coat speed sensor with solid lubricant paste G 000 650.

-

Insert speed sensor into mounting hole in wheel bearing housing and tighten bolt to 8 Nm (71 inch lbs.).

-

Connect speed sensor to speed sensor wiring connector.

-

Turn wheels fully left and right lock and check clearance to speed sensor wiring.

Rotor on front axle, checking or removing and installing 
-

Raise vehicle.

-

Remove wheel.

-

Rotate brake disc and check rotor is damaged or dirty.

-

If rotor is damaged, remove wheel hub with rotor and replace.

Rotor, Checking or Removing and Installing

Rotor on Front Axle, Checking or Removing and Installing

-

Raise vehicle

-

Remove wheel

-

Rotate brake disc and check rotor is damaged or dirty.

-

If rotor is damaged, remove wheel hub with rotor and replace.

Speed Sensor Wiring, Removing and Installing

Front speed sensor wiring, removing and installing 

Special tools and equipment 

-

VAS 1978 Wiring harness repair set

ABS ITT Mark 20 IE|Page 571 > < ABS ITT Mark 20 IE|Page 569