volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Flywheel > < Flex Plate|Service and Repair
Page 2
background image

-

Check dimension -a- through three holes for securing torque converter using a straightedge and depth gauge and calculate average.

-

Compare average (measured distance + thickness of straightedge) with specification.
Specification: 15.7...16.5 mm

If the specification is not obtained:

-

Remove drive plate again and install appropriate shim -1-.

Note:  Only one shim of the appropriate thickness may be used to compensate.

If the specification is obtained:
-

Install new cylinder head bolts and tighten hand tight.

-

Tighten securing bolt to 60 Nm plus additional 90° (1/4 turn - turning further can be done in several stages).

Flywheel > < Flex Plate|Service and Repair