GTI V6-2.8L (BDF) (2002)
^
Press tapered roller bearing outer race with a 1.70 mm thick shim into transmission housing, supporting housing directly under bearing support
with thrust piece 2050.
^
Set complete 5th, 6th and reverse gear output shaft in clutch housing.
^
Install transmission housing and tighten bolts -A- and -B- diagonally to correct torque.
^
Install measuring tools. Put washers with a total thickness of 8 mm on bolt -arrow- securing installation tool VW 792 to clutch housing.
^
Set dial gauge (3 mm measuring range) to zero with 1 mm preload.