GTI V6-2.8L (BDF) (2002)
Indicated on display:
Read measured value block
Input display group number XXX
-
Press buttons -0-, -5- and -6- for "Display group number 56" and confirm entry with -Q- button.
Indicated on display: (1 to 4 = display zones)
Read measured value block 56
->
1
2
3
4
-
Observe display in display zone 4 (4th digit from left).
Specification: xxx0x "Neutral"
-
Depress foot brake and select driving range. Observe figure displayed in display zone 4:
Specification: xxx1x "Driving range selected"
-
Press the -> button.
-
Press buttons -0- and -6- for function "End output" and confirm entry with the -Q- button.
-
Switch off ignition.
If the specifications are not obtained:
-
Checking CAN-bus matching resistor. Refer to "Computers and Control Systems/Information Bus". See: Powertrain Management/Computers and
Control Systems/Information Bus/Testing and Inspection
-
Check DTC memory, repair malfunctions if necessary and then erase DTC memory. Refer to "Displaying and Reading Trouble Codes/With
Manufacturer Scan Tool/DTC Memory Checking and Erasing",Under Powertrain Management/Computers and Control Systems/Testing and
Inspection. See: Powertrain Management/Computers and Control Systems/Testing and Inspection
-
Read readiness code. If the DTC memory has been erased or the Motronic Engine Control Module (ECM) -J220- was disconnected from battery
positive (B+), the readiness code must be generated again.
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code", Under Powertrain Management/Computers and
Control Systems/Testing and Inspection. See: Powertrain Management/Computers and Control Systems/Testing and Inspection