GTI V6-2792cc 2.8L DOHC (AAA) (1996)
Power Door Lock Actuator: Service and Repair
Rear Door Actuator, Removing and Installing
Removing:
-
Remove rear door trim.
-
Partially remove vapor barrier.
-
Disconnect bi-pressure hose -1- from actuator.
-
Disconnect multi-pin harness connector -2- at actuator.
-
Unhook pull and latch rods -3-.
-
Remove rear door latch with actuator. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Latch/Service and Repair
-
Turn latch rotor to "closed" position.
-
Remove Torx T15 bolt -1-.
-
Open retainers (arrows) and disconnect actuator from door latch.
-
When the actuator is removed, locking lever -1- slides out of the slot in striker -2-.
Installing:
-
During installation locking lever -1- must engage striker -2-.
NOTE: If the door latch does not operate properly after the actuator is replaced, the complete assembly should be replaced as a unit.