GTI V6-2792cc 2.8L DOHC (AAA) (1996)
Camshaft: Service and Repair
Removal
LEGEND
1
Bearing Cap
2
Bearing Cap Nut
3
Camshafts
4
Camshaft Sprocket
5
Trigger Wheel
6
Camshaft Sprocket Bolt
7
Cylinder Head Deck Height Measurement Point
8
Cylinder Head
9
Valves
10
Valve Guide
11
Valve Stem Seal
12
Valve Springs
13
Valve Spring Plate
14
Valve Keepers
15
Hydraulic Lifter
NOTE:
-
During removal and installation procedures, refer to the component location illustration above and component notes below.
-
Also refer to Cylinder Head Assembly.
COMPONENT NOTES
Bearing Cap (1)
-
Note installed position.
-
Note installation and tightening sequence.
Bearing Cap Nut (2)
-
Tighten to: 20 Nm (15 ft. lbs.).
Camshafts (3)
-
Check axial clearence with lifters removed.
-
Axial clearence: 0.15 mm (0.0060 inch)
-
Radial clearence: 0.1 mm (0.0039 inch)
-
Maximum runout: 0.01 mm (0.0004 inch)