GTI 1.8L T L4-1.8L Turbo (AWP) (2002)
If specified value is obtained:
-
Connect test box to control module wiring harness. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading
and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
-
Check wire between test box socket 115 + 2-pin connector terminal 2 for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
-
Check wires for short circuit to B+ and Ground (GND).
Specified value: Infinite Ohms
-
Check wire between 2-pin connector terminal 1 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
If resistances and wires are OK.
-
Replace Motronic Engine Control Module (ECM) -J220-.