Jetta L4-1.8L Turbo (AWD) (2000)
Spoiler: Service and Repair
Stoplight, Removing and Installing
Stoplight, Removing And Installing
Installing
CAUTION:
-
Primer dries very fast and permanently stains painted surfaces.
-
If any visible part of the vehicle gets stained with primer, clean it thoroughly before primer dries.
-
Slide stoplight wiring harness through hole in stoplight support - 1 -.
-
Route wiring harness through drill hole in spoiler and pull wiring harness from support base - 2 -.
NOTE: Make sure that stoplight is pulled tight to support, and if needed adjust slack in wiring harness.
-
Attach stoplight to spoiler by screwing stoplight - 1 - into spoiler support base.
-
Insert wiring harness into grommet - 1 -.
-
Pull grommet toward spoiler support base - arrow -.
Removing
-
Removal of stoplight once spoiler has been installed to vehicle is impossible, in that case, whole spoiler kit has to be replaced
-
If spoiler has not yet been installed remove in reverse order of installing