Jetta L4-1.9L DSL Turbo (AAZ) (1997)
Rear Caliper Piston Dust Seal Installing
- Install dust boot onto piston.
Piston Into Rear Caliper Installing
- Hold piston in front of caliper housing and insert inner sealing lip into cylinder groove using VAG 1474/5.
Rear Caliper Piston Returning
- Turn knurled wheel of tool clockwise to install piston.
CAUTION! The collar of the tool (arrow) must be next to the caliper piston
NOTE:
If piston is difficult to turn use open-end 13 mm wrench on flats provided (arrow -A-).
- Install brake pads.
Rear Caliper Pre Bleeding
- Open bleed screw (left arrow) and fill with brake fluid from container until brake fluid flows from brake line connection (right arrow) without
bubbles.
- Close bleed screw.