Jetta L4-1.9L DSL Turbo (AAZ) (1997)
Ignition Lock Cable: Adjustments
NOTE: Locking cable must always be adjusted in installation position.
-
Shift selector lever into "1" position.
-
Turn ignition key to right (starting position) and release.
-
Adjust clearance to 0.7 mm between lever -1- and locking pin -2- by sliding locking cable casing.
Dimension a = 0.7 mm
-
Tighten locking cable anchorage screw in this position to 6 Nm (53 inch lb).
-
Shift selector lever into "P" position and turn ignition key to end position.
-
Pull out ignition key.
-
It must only be possible to remove ignition key in this selector lever position.
-
Selector lever cannot be shifted out of "P" position.