Jetta L4-1.9L DSL Turbo (BEW) (2004)
/Page-474001.png)
Valve Cover: Service and Repair
Removing and installing cylinder head cover
Special tools, testers and auxiliary items required
-
Torque wrench (5 ... 50 Nm) V.A.G. 1331
-
Sealant AMV 174 004 01
Removing
-
Remove engine cover by pulling forward edge of engine cover abruptly upward - arrow - - and pulling forward out of rear securing clips - arrow B
-
-
Remove EGR valve.
-
Remove toothed belt guard - upper part.
-
Disconnect crankcase breather hose at union of charge air pipe at rear.
-
Remove cylinder head cover.
Installing
Note: Replace cylinder head cover gasket and seal for bolts if damaged.
Installation is performed in the reverse sequence of removal. In the process, note the following:
