Jetta L4-1.9L DSL Turbo (BEW) (2004)
Note:
Repair should be performed on maximum of 4 lines.
The following are general instructions. Always read and follow the instructions of the product:
^
Ignition and heated rear window switches OFF.
-
Clean interior surface of rear window with glass cleaner.
-
Using transparent tape, place a strip of tape (approx. 25 mm) horizontally on the top and bottom of the inoperative line(s) at the gap (do not cover the
line or the gap with tape).
-
Shake the bottle of Permatex well.
-
Apply Permatex(R) product (using a small brush) over the damage, extend repair approx. 6 mm beyond the break in both directions.
-
Wait until product is dry (approx. 30 seconds).
-
Repeat application three times.
-
Remove tape after 30 minutes.
^
Wait 24 hours before switching the heated rear window ON.
Note:
Lines damaged by outside influence are not covered by the New Vehicle Limited Warranty.
When procedure applies to vehicles with-in the New Vehicle Limited Warranty, use the table shown.