Jetta L4-1.9L DSL Turbo (BRM) (2006)
Sealing Flange, Engine Front: Service and Repair
Sealing Flanges and Flywheel/Drive Plate Assembly Overview
Sealing flanges and flywheel, removing and installing
Assembly overview
1 - Seal
^
Do not add oil or grease sealing lip of sealing ring
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
2 - Sealing flange, belt pulley side
^
Must be located on dowel sleeves
^
Insert with Silicone sealant D 176 404 A2
3 - Cylinder block
4 - 60 Nm plus an additional 90° (1/4 turn)
^
Replace
5 - Flywheel
^
To remove and install flywheel, secure using flywheel retainer 3067
6 - Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage or bend when doing assembly work
7 - 15 Nm
^
Replace
8 - Sealing flange with seal
^
Replace only complete with seal and sensor wheel