Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Jetta L4-1781cc 1.8L SOHC (ACC) Can (1995)

Engine, Cooling and Exhaust > Engine > Drive Belts, Mounts, Brackets and Accessories > Ribbed Belt <--> [Drive Belt] > Component Information > Service and Repair > Drive Belt With Tensioner > Page 1437

Page 1
background image

Ribbed Belt: Service and Repair
Drive Belt W/O Tensioner

Ribbed belt removing and installing

Belt drive without tensioner

Note:

-

Before removing the ribbed belt, mark its running direction so that it can be reinstalled the same way.

-

when installing, be sure belt is correctly seated in pulleys

Removing

- Loosen Generator (GEN) mounting bolts -1- and -2- at least 1 turn.
- Press down Generator with lever 3297 and remove ribbed belt from Generator pulley.
- Remove V-belt for power steering pump.
- Remove ribbed belt.

Installing

- Place ribbed belt on crankshaft vibration damper/pulley and on coolant pump pulley.
- Install V-belt for power steering pump.

- With lever 3297, push Generator down to stop at least 3 times to ensure ease of movement.

Note:

If the engine has not yet been installed in the vehicle, stop here and continue the installation procedure after the engine is installed.

- With lever 3297, push Generator down and place ribbed belt on pulley.
- While Generator is still loose, let engine idle for at least 10 seconds.

Note:

Follow tightening sequence when tightening Generator mounting bolts. Do not lean on Generator and do not touch ribbed belt.

Engine, Cooling and Exhaust > Engine > Drive Belts, Mounts, Brackets and Accessories > Ribbed Belt <--> [Drive Belt] > Component Information > Service and Repair > Drive Belt With Tensioner > Page 1437

[PREV PAGE] [NEXT PAGE]