Jetta L4-2.0L (AEG) (2000)
-
Remove camshaft drive belt guard upper section.
-
Set camshaft sprocket to cyl. 1 TDC by turning the crankshaft.
^
Mark on camshaft sprocket must align with arrow on toothed belt guard.
-
Release tensioning roller and take toothed belt off camshaft sprocket.
-
Turn crankshaft back slightly.
-
Remove camshaft sprocket using 3415 counter-hold (Remove bolts from holes -arrows- before using tool).
-
Remove woodruff key from camshaft.
-
Remove valve cover.
-
First remove bearing caps 5, 1 and 3, then loosen bearing caps 2 and 4 alternately and diagonally.
Installing
Conditions
^
Pistons must not be positioned at TDC.
Note:
^
When installing the camshaft No. 1 cylinder cam lobes must point upward.
^
When installing the bearing cap note offset, before installing camshaft fit bearing caps and determine fitting position.