Jetta L4-2.0L (AEG) (2000)
pipe strainer.
-
Apply silicone sealant bead (as shown) to a clean sealing surface on sealing flange.
-
Immediately install sealing flange and slightly tighten all bolts.
Note:
-
Use guide sleeve from 2080A to install sealing flange with oil seal already installed.
-
Tighten sealing flange mounting bolts using alternate sequence.
Tightening torque: 15 Nm (11 ft. lbs.)
-
Install oil pan.
Note:
-
After installing, allow sealant to dry for approx. 30 minutes before filing with engine oil.
-
Install crankshaft toothed belt sprocket and hold with 3415 counter-hold.
Tightening torque: 90 Nm (66 ft. lbs.) + 1/4 turn (90°)
-
Install toothed belt and adjust timing.
-
Install ribbed belt.