Jetta L4-2.0L (AEG) (2000)
-
Check wires between test box and 5-pin connector for open circuit according to wiring diagram.
Terminal 3 + socket 12
Terminal 4 + socket 11
Terminal 5 + socket 13
Wire resistance: max: 1.5 Ohms
Vehicles with engine code AVH, AZG
-
Check wires between test box and 5-pin connector for open circuit according to wiring diagram.
Terminal 3 + socket 27
Terminal 4 + socket 53
Terminal 5 + socket 29
Wire resistance: max: 1.5 Ohms
Continuation for all vehicles
-
Also check wires for short circuit to each other, to vehicle Ground (GND) and to B+. Specified value: Infinite Ohms
If no DTCs are found in wires:
-
Replace Mass Air Flow (MAF) Sensor -G70-, item no. 3.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes