Jetta L4-2.0L (AEG) (2000)
Electronic Brake Control Module: Service and Repair
Hydraulic Unit/ABS Control Module, Removing And Installing
Required Special Tools And Equipment
^
VAG 1331 Torque wrench or equivalent
^
VAG 1410 Torque wrench or equivalent
^
VAG 1869/2 Brake pedal depressor or equivalent
Additional Required Information Sources
^
ABS, ABS/EDL On Board Diagnostic (OBD) Refer to Powertrain Management; Computers and Control Systems.
Component Location:
The ABS control module is bolted together with the hydraulic unit and is located in the engine compartment, left side.
Caution!
^
Brake lines in the area of the hydraulic unit should not be bent!
Removing
-
For vehicles with a coded radio, obtain code.
-
Disconnect battery.
-
Disconnector connector -1- of Mass Air Flow MAF sensor from air filter tube
-
Remove bolts -2- at air filter -3- and move filter to left side.
-
On vehicles with Diesel engines, remove relay panel above brake booster.
-
Remove as much brake fluid as possible from brake fluid reservoir using a brake bleeder bottle.