Jetta L4-2.0L (AEG) (2000)
(arrow).
If display jumps to approx. -46 °C:
-
Press -> button.
-
Press buttons -0- and -6- to select "End Output" function 06 and press -Q- button to confirm input.
-
Turn off ignition.
-
Replace Engine Coolant Temperature (ECT) sensor -G62- with Engine Coolant Temperature (ECT) sensor -G2-. Refer item -19- See: Powertrain
Management/Fuel Delivery and Air Induction/Locations
-
Check DTC memory. If necessary, repair any malfunctions and erase DTC memory.
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading
Diagnostic Trouble Codes
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Clearing
Diagnostic Trouble Codes
-
Display readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If DTC memory has been erased or the Engine Control Module (ECM) was disconnected from permanent battery (B+) voltage, generate the
readiness code again. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If display remains at approx. 141°C:
-
Press -> button.
-
Press buttons -0- and -6- to select "End Output" function 06 and press -Q- button to confirm input.
-
Turn off ignition.
-
Check wiring according to wiring diagram.
Checking wiring
-
Remove wiper arms and plenum chamber cover.
-
Connect VAG1598/22 test box to control module wiring harness.