Jetta L4-2.0L (AEG) (2000)
Back Window Glass: Service and Repair
Undamaged Rear Window, Removing
Undamaged Rear Window, Removing
-
Disconnect connectors for heated rear window and press connector tabs onto window.
-
Remove parcel shelf.
-
Removing upper C-pillar trim.
-
Loosen sealing lip from window flange using plastic wedge and spray in Cleaning solution D 009 401 04 (as a substitute for lubricant).
-
Insert cutting cord into window flange using small tube.
NOTE: Press in cutting cord far enough to prevent damage to lip/spacer.
-
Push cutting cord through adhesive sealant into vehicle interior using awl (from V.A.G1474A).
-
Pull through outer cord end inward and counterhold using Pulling grip V.A.G1351/1.
-
Secure inner cord end to spooling tool.
-
Position Spooling tool V.A.G1654.
-
Insert protective foil -1 - (V.A.G 1474/14) between rear window and headliner.
-
Move spooling tool according to position required and cut windshield free.
-
While cutting free, press cutting cord against window using plastic wedge in order to have clearance from window flange.
-
In place of Spooling tool V.A.G1654, spooling tool V.A.G1654A can also be used.