Jetta L4-2.0L (AEG) (2000)
-
Place carrier assembly on a level surface, support if necessary.
-
Checking relay pulleys, guide rails and seal for damage. Replace carrier assembly if damaged.
-
Locate start and end of diagonal Bowden cable -4-. Do not damage diagonal Bowden cable -4-, this is not replaced.
-
Bowden cables -2- and -6-, which come from cable reel -5-, must be cut through in guide rails -3- and -7-.
-
Slide coupling plate and clamping brackets -1- on guide rails into topmost position. It is only possible to remove coupling plate with clamping
brackets here.
-
Fold coupling plate and clamping brackets -1- in direction of -arrow-. When doing this, note position of Bowden cables -2- and -3- in coupling
plate.
-
Remove cut-off ends of Bowden cables from coupling plates.
-
Diagonal Bowden cable must not be changed in its installation position.
Removing crank mechanism (vehicles with mechanical window regulators)