Jetta L4-2.0L (AZG) (2004)
-
Remove screw -arrow- from plastic retainer.
-
Lift retainer as far as the electrical harness allows.
-
Remove lower part of retainer base plate and remove telematic control module.
-
First disconnect 42-pin connection from control module, as follows:
-
Depress clip -arrow1- and slide locking lever in direction of -arrow2-.
-
Then disconnect antenna cable connections from control module.
Installing
Install in reverse order of removal, noting the following:
-
When reinstalling plastic retainer, first insert/lay into spare tire well as illustrated.
-
Then, slide retainer forward (in direction of -arrow-) until the screw hole in the retainer lines up with the threaded insert underneath.
-
Insert screw into screw hole in retainer and tighten.
If telematics control module was replaced:
-
Code telematics control module.
-
Reconfigure telematics system for OnStar(R) functions.