Jetta L4-2.0L (AZG) (2004)
On opposite side of carrier:
^
Using a small flat blade screw driver to press lock tabs on three mounting pins (arrows) inward while applying downward pressure to regulator
with finger (as shown).
Tip: Note placement of foam isolator washers at each mounting pin location (may come off with motor).
Tip: New washers are included in kit and must be installed between window regulator and motor on final assembly of motor to regulator.
^
Clean any grease and dirt from tracks and around regulator insertion hole (arrow).
^
Carrier assembly is now ready to install new cables.
Regulator assembly, preparing for installation
^
Remove three foam washers from assembly.
^
Unfold cables, tie wraps (arrows) through center of assembly are removed later in procedure).
Tip: Orientation of tie wraps should be such that the locking block of the tie wrap does not interfere with installation of regulator to the carrier
assembly.
Regulator/cable assembly, installing