Jetta L4-2.0L (AZG) (2004)
/Page-600004.png)
Note:
^
When installing the camshaft, the cam lobes for cylinder 1 must be facing up.
^
When installing the bearing cap note offset. Before installing camshaft determine installed position.
Work sequence
-
Oil running surfaces on camshaft.
-
Install camshaft.
-
Tighten bearing caps 2 and 4 alternately and diagonally to 20 Nm.
-
Coat contact surfaces of bearing cap 1 lightly with sealing compound AMV 174 004 01.
-
Install bearing caps 3, 1 and 5 and also tighten to 20 Nm.
-
Install toothed belt.
Note: When new hydraulic lifters have been installed the engine must not be started for about 30 minutes. The hydraulic compensation elements
must settle or the valves will strike the pistons.
