Jetta L4-2.0L (AZG) (2004)
-
Install new seal -2- with bulge facing fuel tank.
-
Place connector -1- in direction of arrow against fuel gauge sender behind fuel supply unit.
Note: The working area of the float must not be reduced.
-
Install locking device -3- so that arrow -A- is parallel to vehicle longitudinal axle and faces backward, -B-.
-
Tighten nuts -2- in a diagonal sequence.
Torque setting: 7 Nm
-
Connect 4-pin connector -1-.
-
Adapt (match) engine control module to throttle valve control module, Refer to Adapting components and functions.
-
Generate readiness code again if DTC memory has been erased or engine control module was disconnected from permanent positive,Refer to
Adapting components and functions.