Jetta L4-2.0L (AZG) (2004)
-
Using a screwdriver, lift cover of multi-pin connector and remove.
-
Using a small screwdriver, push purple latch in direction of arrow.
Pin assignment of harness connector T25 and ABS Control Module (w/EDL) -J1 04
Pin Connected to component:
19 + 20 Right Front ABS Wheel Speed Sensor -G45
1 + 2 Left Front ABS Wheel Speed Sensor -G47
-
Using extractor tool from wiring harness repair set VAS 1978, push out applicable terminals.
-
Disconnect wheel speed sensor wiring connector.
-
Replace faulty wheel speed sensor wiring.
-
Connect speed sensor to speed sensor wiring.