Jetta L4-2.0L (AZG) (2004)
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
Sensor and Sensor Control Check
Oxygen Sensor (O2S) And Oxygen Sensor Control Before Three Way Catalytic Converter (TWC), Checking
NOTE:
-
Vehicle must be raised before connector for oxygen sensor is accessible.
-
When servicing terminals in harness connector of Heated Oxygen Sensor (HO2S), use only gold-plated terminals.
Recommended special tools and equipment
-
VAG1526 multimeter or VAG1715 multimeter
-
VAG1594 connector test kit
-
Wiring diagram
Test requirements
-
The respective fuses of Heated Oxygen Sensor (HO2S) -G39- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers like, for example, lights and rear window heating must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
-
Exhaust system must be properly sealed between catalytic converter and cylinder head.
-
Coolant temperature must be at least 80 degree C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic
Mode 1: Check Measured Values
-
Oxygen sensor heater for oxygen sensor before catalytic converter must be OK, check.
Function test (Vehicles with engine code AEG)
-
Select the oxygen sensor test results and check whether the specified values are being reached, Diagnostic mode 5: Check output of oxygen sensor
signals.
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Check primary voltage.
Checking primary voltage