Jetta L4-2.0L (AZG) (2004)
-
Remove hex bolts -1 - and - 2 - .
-
Take out pump.
Installing
-
Fill power steering pump with hydraulic fluid.
-
Fill the pump with fluid through the intake line.
-
Turn hub by hand until oil runs out of the pressure side.
-
Install power steering pump on bracket and tighten bolts to 25 Nm (18 ft. lbs.).
-
Install intake hose and install spring-type clip.
-
The mark - arrow A - must align with casting seam - arrow -
-
The spring-type clip must close off mark - arrow B - .
-
Install new sealing rings onto banjo bolt.
-
Tighten banjo bolt to 38 Nm (28 ft. lbs.).
-
Installation is continued in reverse sequence
With High Mounted Power Steering Pump, Removing and Installing
P.A.S. power steering pump, vehicles with high mounted power steering pump, removing and installing