Jetta L4-2.0L (AZG) (2004)
-
Remove noise insulation tray.
-
Place oil pan under vehicle.
-
Press tie rod end off steering arm. .
1 - Ball joint puller (commercial type) e.g. Matra V 176
For R32
-
Press tie rod end off steering arm.
-
If the bushing - 3 - is pressed out while pressing out tie rod, it must be pressed in again.
-
Attach special tools as shown in the illustration, and tighten spindle to 50 Nm (36.8).
Then, the bushing is correctly positioned in the steering arm again.
1 - Assembly tool 3293
2 - Installing tool 40 - 503
Continued for all vehicles
-
Disconnect hoses from steering gear and seal with plastic bag and adhesive tape.