Jetta L4-2.0L (AZG) (2004)
-
Loosen transverse link connection bolt on subframe.
-
Disconnect axle shaft - 1 - from final drive flange shaft - 2 -
-
Install tools as shown in illustration.
-
Pull out ball joint by tightening the spindle.
Installing upper ball joint
-
Install tools as shown in illustration.
-
Pull in ball joint -1 - by turning the spindle.
Tighten vehicle to the lifting platform
Caution: If the vehicle is not secured, there is a risk that it may slip off the hoist.
-
Remove plugs from trailing arm - 3 - and tighten tensioning strap.
1 - Support arm of lifting platform