Jetta L4-2.0L (AZG) (2004)
Installing left-hand flange shaft seal
-
Drive in new seal until thrust piece contacts stop. Ensure that seal remains straight when driving.
-
Insert flange shaft.
-
Apply sealant D 176 404 A2 to head of countersunk bolt.
-
Secure flange shaft with countersunk bolt.
-
Connect ball joint to control arm using new bolts onto old impression marks.
-
Bolt left-hand drive shaft to flange shaft.
-
Install wheel.
-
Check and top up ATF level with transmission installed.
-
Install sound insulation tray.
Tightening torques
Flanged shaft to transmission (conical 25 Nm head bolt)
Drive shaft to flanged shaft:
Refer to Drive Axles, Bearings and Joints.
Ball joint to control arm:
Refer to Steering and Suspension.
Wheel bolts to wheel hub:
Refer to Steering and Suspension.
Oil seal for right flanged shaft, replacing