Jetta L4-2.0L (AZG) (2004)
-
Tighten nuts -arrows A- to 10 Nm.
-
Tighten both bolts -arrows B- to 25 Nm.
-
Insert protective sleeve of selector lever cable in cover.
-
Install tunnel heat shields front and center.
-
Fit selector lever cable in bracket on front heat shield.
-
Reconnect exhaust system.
-
Fit selector lever cable -1- in retainer -arrow- on engine.
-
Loosen bolt -2- at front ball socket of selector lever cable -1-.
-
Place selector lever cable in support bracket/transmission and push onto lever/selector shaft -4- using a pair of pliers.
-
Fit new circlip -3- to selector lever cable at support bracket/transmission.
-
Tighten bolt -2- (13 Nm).
-
Check selector mechanism.