Jetta L4-2.0L (AZG) (2004)
Shifter A/T: Service and Repair
4 Speed Automatic 01M
Selector Lever
Selector lever, removing and installing
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery ground strap.
Removing
-
Push down sleeve -5- on selector lever handle with two screwdrivers.
-
Pull selector lever handle off upward.
-
Remove center console and extension.
-
Disconnect locking cable from the selector mechanism locking lever.
-
Disconnect cable tie -1- from selector lever housing.
Note: Do not damage wiring!
-
Pry retainer for connector -2- carefully out of selector lever housing with a screwdriver.
-
Separate connectors -3- for shift lock solenoid and -4- for selector lever position display.
-
Release selector mechanism cover strip retaining tabs -6- (Qty. 4) by hand and pry off.
-
Carefully pry off frame at four corners -7- and remove. Note contact spring for selector lever position display!
-
Remove front selector mechanism securing nuts (Qty. 2).