Jetta L4-2.0L (AZG) (2004)
-
Hold axle shaft and joint horizontal and using the other hand slowly slide joint back.
-
Mark installation position of rollers -1 - to triple roller star -2 - using a felt tipped pen.
-
Take off rollers -1 - and place on a clean surface.
-
Remove circlip.
-
Pliers (commercially available)
-
Insert axle shaft in press.
-
Hold axle shaft, then press triple roller star off axle shaft.
-
Pull joint with joint protective boot off shaft. - Clean shaft, joint and groove for oil seal.
Assembling
-
Slide small clamp for joint protective boot onto shaft.
-
Slide joint protective boot onto shaft.
-
Slide joint onto shaft.