Jetta L5-2.5L (BGP) (2006)
-
Switch ignition off and open hood
-
Pull engine cover out of retainers first at front -arrow 1-, then at right rear -arrow 2- and lastly at left rear -arrow 3-
-
Carefully pivot engine cover out from rear area
-
Lift left side -arrow 1 and 2- of engine cover up to allow inspection of fuel feed hose to fuel rail connection without disconnecting MAF sensor
or air intake tube
-
Perform the following four checks. If any one check is not met proceed to Section B and replace fuel feed hose spring clip
WARNING: Use hands only while trying to rotate fuel feed hose, as damage may occur to the fuel feed hose when using tools.
Check 1
-
Attempt to rotate fuel feed hose on fuel rail
-
If hose does not rotate on fuel rail proceed to Check 2
-
If hose rotates on fuel rail, proceed to Section B
Check 2
NOTE: Pictures are shown with parts off the vehicle for demonstration purposes