Jetta V6-2.8L (BDF) (2002)
Note: Ensure the roller rocker fingers and the support elements are not interchanged.
-
Remove spark plugs with spark plug wrench 31 22B.
-
Set piston of corresponding cylinder to "bottom dead center".
-
Fit assembly appliance 2036 with adapter plates 2036/1 and adjust mountings.
-
Screw adapter T40012 into threaded hole for spark plug and apply a continuous pressure of at leas 6 bar
-
Remove valve springs with assembly lever VW 541/1A and thrust piece VW 541/6.
Note: Tight covers can be loosened by tapping lightly on the cover with a hammer.
-
Pull off valve stem seals with puller 3364.
Installing
-
Prevent damage to new valve stem seals by sliding plastic sleeve -A- over valve stem.
-
Oil sealing lip of valve stem seal -B- insert in fitting tool 3365 and carefully push onto valve guide.
-
Install camshafts.