Jetta V6-2.8L (BDF) (2002)
Special tools, testers and auxiliary items required
^
Hydraulic removal and installing tool for wheel bearing V.A.G. 1459 B
^
Piston cylinder HKZ-15 with hydraulic press piece E0-204-T
^
Removal rods E-0-217+218
^
Special nut E-8-214
Thrust tube E-5
^
Thrust tube E-10
^
Press sleeve E-13-1
^
Thrust bolt E-15
^
Supplementary set V.A.G. 1459 B/2
^
Bell E-40
-
Lift vehicle until the load on the front axle is relieved.
-
Loosen 12-point nut.
-
Lift vehicle to installing height.
-
Remove wheel.
The following three work steps are necessary only for vehicles with modified stabilizer bar mounting.
-
Loosen upper hex nuts of connecting links from left and right suspension strut.
-
Pull out clamp on brake hose bracket and release brake hose.
-
Release speed sensor wiring from front suspension strut.